1、功能说明
    1、通过设定闹钟时间来触发闹钟中断。
    2、通过闹钟标志位来配置IO输出

2、使用环境

    软件开发环境：KEIL MDK-ARM V5.34
                  IAR EWARM 8.50.1 
    芯片支持：
        N32H730  
        N32H735   
        N32H735EC
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787
    开发板支持：
        N32H787_EVB
        N32H787_HMI
        N32H787_EVB_PRO

3、使用说明
    
    系统配置:
        1、RTC时钟源：LSE
        2、闹钟IO输出：PC13
        3、串口配置：
                    - 串口为USART1（TX：PA9  RX：PA10）:
                    - 数据位：8
                    - 停止位：1
                    - 奇偶校验：无
                    - 波特率： 115200 
    使用方法：
        编译后烧录到评估板，上电，串口按照闹钟设定时间(间隔1min)打印输出并且在PC13口会出现一个脉冲。

4、注意事项
    无
    

1. Function description
   1. Trigger the alarm interrupt by setting the alarm time.
   2. Configure the IO output through the alarm flag.

2. Development environment

    Software development environment: KEIL MDK-ARM V5.34
                                      IAR EWARM 8.50.1 
    Supported chips:
        N32H730  
        N32H735   
        N32H735EC
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787
    Development board support：
        N32H787_EVB
        N32H787_HMI
        N32H787_EVB_PRO

3. How to use

    System configuration:
        1. RTC clock source: LSE
        2. alarm IO output: PC13
        3. Serial port configuration:

                            - Serial port: USART1 (TX: PA9 RX: PA10) :
                            - Data bit: 8
                            - Stop bit: 1
                            - Parity check: None
                            - Baud rate: 115200

    Instructions:
        After compiling, it is burned to the evaluation board, powered on, and the serial port prints the output according to the time set by the alarm (1 minute by default) 
        and generate a pulse on PC13 pin.

4. Attention
    None

