1、功能说明

    该测例演示了USARTx与PC间通过查询检测标识实现的基础通信。
    重定向printf函数至USARTx，并使用printf函数输出消息至终端。
    USARTx是USART3。


2、使用环境

    软件开发环境：KEIL MDK-ARM V5.34
			     IAR EWARM 8.50.1 

    芯片支持：
        N32H730  
        N32H735   
        N32H735EC
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787

3、使用说明
    系统配置
        1、时钟源：HSI+PLL
        2、系统时钟频率：
            N32H760系列：    600MHz

        3、 USART配置如下：
    - 波特率 = 115200 baud
    - 字长 = 8数据位
    - 1停止位
    - 校验控制禁用
    - 硬件流控制禁用（RTS和CTS信号）
    - 接收器和发送器使能
    
    USART引脚连接如下：
    - USART3_Tx.PD8
    
    测试步骤与现象：
    - Demo在KEIL环境下编译后，下载至MCU
    - 复位运行，查看串口打印信息


4、注意事项




1. Function description

     This test example demonstrates the basic communication between USARTx and PC by querying the detection flag.
     Redirect the printf function to USARTx, and use the printf function to output messages to the terminal.
     USARTx can be USART3.


2. Development environment

    Software development environment: KEIL MDK-ARM V5.34
			                                            IAR EWARM 8.50.1 
   
    Supported chips:
        N32H730  
        N32H735   
        N32H735EC
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787     

3. How to use
    
    System Configuration:
        1. Clock source: HSI+PLL
        2. System Clock frequency: 
            N32H760 series:     600MHz

     3、USART is configured as follows:
     - Baud rate = 115200 baud
     - Word length = 8 data bits
     - 1 stop bit
     - checksum control disabled
     - Hardware flow control disabled (RTS and CTS signals)
     - Receiver and transmitter enable
    
     The USART pins are connected as follows:
     - USART3_Tx.PD8
    
     Test steps and phenomena:
     - Demo is compiled in KEIL environment and downloaded to MCU
     - reset operation, view serial port printing information


4. Attention
    none