1、功能说明

    该测例演示了LPUARTx与PC间通过查询检测标识实现的基础通信。
    重定向printf函数至LPUARTx，并使用printf函数输出消息至终端。
    LPUARTx是LPUART1。

2、使用环境

    软件开发环境：KEIL MDK-ARM V5.34
    		  IAR EWARM 8.50.1
    
    芯片支持：
          N32H760 系列
          N32H762 系列
          N32H765 系列  
          N32H785 系列	
          N32H787 系列		  

3、使用说明
    系统配置
        1、时钟源：HSI+PLL
        2、系统时钟频率：
             600MHz

    LPUART配置如下：
    - 波特率 = 115200baud
    - 字长 = 8数据位（固定）
    - 1停止位（固定）
    - 校验控制禁用
    - 硬件流控制禁用（RTS和CTS信号）
    - 接收器和发送器使能
    
    LPUART引脚连接如下：
    - LPUARTx_Tx.PA9
    
    测试步骤与现象：
    - Demo在KEIL环境下编译后，下载至MCU
    - 复位运行，查看串口打印信息

4、注意事项
    无

1. Function description

This test example demonstrates the basic communication between the LPUART and the PC by querying the detection flag.
     Redirect the printf function to the LPUART, and use the printf function to output messages to the terminal.
LPUARTx, is LPUART1.

2. Development environment

    Software development environment: KEIL MDK-ARM V5.34
    		                      IAR EWARM 8.50.1
   
    Supported chips:
          N32H760 series
          N32H762 series
          N32H765 series  
          N32H785 series	
          N32H787 series		  

3. How to use
    
    System Configuration:
        1. Clock source: HSI+PLL
        2. System Clock frequency: 
              600MHz

      3、The LPUART configuration is as follows:
     - Baud rate = 115200 baud
     - Word length = 8 data bits (fixed)
     - 1 stop bit (fixed)
     - checksum control disabled
     - Hardware flow control disabled (RTS and CTS signals)
     - Receiver and transmitter enable
    
     The LPUARTx pins are connected as follows:
     - LPUARTx_Tx.PA9
    
     Test steps and phenomena:
     - Demo is compiled in KEIL environment and downloaded to MCU
     - reset operation, view serial port printing information

4. Attention
    None