1、功能说明
    1、读写擦NAND Flash MT29F1G08ABAEAWP-IT

2、使用环境

    软件开发环境：KEIL MDK-ARM V5.34
                  IAR EWARM 8.50.1 
    芯片支持：
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787
    开发板支持：
        N32H787_EVB

3、使用说明
    
    系统配置:
        1、时钟源： HSI+PLL
        2、系统时钟频率：
            M7核 : 600MHz 
        3、串口配置：
                - 串口为USART1（TX：PA9  RX：PA10）:
                - 数据位：8
                - 停止位：1
                - 奇偶校验：无
                - 波特率： 115200
        4、GPIO配置：
                D0:PD14     D1:PD15     D2:PD0      D3:PD1
                D4:PE7      D5:PE8      D6:PE9      D7:PE10
                NOE:PD4     NWE:PD5     CLE:PD11    ALE:PD12
                NCE2:PG9    BUSY:PG7
        
    使用方法：
        编译后烧录到评估板，上电，串口打印NAND Flash ID和读写擦结果

4、注意事项
    只有N32H787_EVB开发板支持Nand-Flash
    

1. Function description
    Read, write and erase NAND Flash MT29F1G08ABAEAWP-IT

2. Development environment

    Software development environment: KEIL MDK-ARM V5.34
                                      IAR EWARM 8.50.1 
    MCU support:
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787
    Development board support：
        N32H787_EVB

3. How to use

    System configuration:
        1. Clock source: HSI+PLL
        2. System Clock frequency: 
            M7 Core：600MHz 
        3. Serial port configuration:
                - Serial port: USART1 (TX: PA9 RX: PA10) :
                - Data bit: 8
                - Stop bit: 1
                - Parity check: None
                - Baud rate: 115200
                
        4.GPIO configuration：
                D0:PD14     D1:PD15     D2:PD0      D3:PD1
                D4:PE7      D5:PE8      D6:PE9      D7:PE10
                NOE:PD4     NWE:PD5     CLE:PD11    ALE:PD12
                NCE2:PG9    BUSY:PG7

    Instructions:
        After compiling, burn it to the evaluation board, power it on, and print the NAND Flash read-write-erase results through the serial port

4. Attention
    Only the N32H787_EVB development board supports Nand-Flash.

