1、功能说明
    此例程展示了CM4内核下通过设定闹钟时间来触发闹钟中断。

2、使用环境

    软件开发环境：KEIL MDK-ARM V5.34
                  IAR EWARM 8.50.1 
    芯片支持：
        N32H785
        N32H785xxxEC
        N32H787
    开发板支持：
        N32H787_EVB
        N32H787_HMI
        N32H787_EVB_PRO

3、使用说明

    系统配置
        1、RTC时钟源：LSE
        2、闹钟IO输出：PC13
        3、串口配置：
                    - 串口为USART1（TX：PA9  RX：PA10）:
                    - 数据位：8
                    - 停止位：1
                    - 奇偶校验：无
                    - 波特率： 115200 

    使用方法：
        编译后烧录到评估板，上电，串口按照闹钟设定时间(间隔1min)打印输出
        
4、注意事项
    无
    
1. Function description

    This example shows the trigger the alarm interrupt by setting the alarm time in the condition of CM4.

2. Development environment

    Software development environment: KEIL MDK-ARM V5.34
                                      IAR EWARM 8.50.1 
    MCU support:
        N32H785
        N32H785xxxEC
        N32H787
    Development board support：
        N32H787_EVB
        N32H787_HMI
        N32H787_EVB_PRO

3. How to use

    System Configuration:
        1. RTC clock source: LSE
        2. alarm IO output: PC13
        3. Serial port configuration:

                            - Serial port: USART1 (TX: PA9 RX: PA10) :
                            - Data bit: 8
                            - Stop bit: 1
                            - Parity check: None
                            - Baud rate: 115200

     Instructions:
         After compiling, it is burned to the evaluation board, powered on, and the serial port prints the output according to the time set by the alarm (1 minute by default) 

4. Attention
    None

