1. 功能说明
    USB DFU 设备

2. 使用环境

    软件开发环境：KEIL MDK-ARM V5.34
                  IAR EWARM 8.50.1 
    芯片支持：
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787
    开发板支持：
        N32H787_EVB
        N32H787_HMI
        N32H787_EVB_PRO


3. 使用说明
    描述相关模块配置方法；例如:时钟，I/O等 
         1. SystemClock：HSE_PLL 600MHz
         2. USBHS Clock: HSE 25MHz

    描述Demo的测试步骤和现象 
         1. 编译后下载程序复位运行；
         2. 通过 USB 线连接 USB1/USB2 口，电脑识别出DFU设备


4. 注意事项
   1. 可通过修改宏定义 USE_USB_HS_IN_FS 或 USE_USB_HS_IN_HS 切换设备为全速模式或者高速模式；
      另外需要使用10MHz、12MHz、19.2MHz、24MHz、25MHz、27MHz、30MHz、或40MHz外部晶体。

1. Function description
    USB DFU device

2. Use environment
    Software development environment: KEIL MDK-ARM V5.34
                                      IAR EWARM 8.50.1 
    MCU support:
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787
    Development board support：
        N32H787_EVB
        N32H787_HMI
        N32H787_EVB_PRO

3. Instructions for use
    Describe the configuration method of related modules; for example: clock, I/O, etc. 
        1. SystemClock: HSE_PLL 600MHz
        2. USBHS Clock: HSE 25MHz

    Describe the testing steps and phenomena of the Demo
    1. After compiling, the downloaded program is reset and run;
    2. Connect a USB cable to the USB1/USB2 port. The computer identifies the DFU device
        
4. Matters needing attention
    1. The device can be switched to Full-Speed mode or High-Speed mode by modify the macro definition USE_USB_HS_IN_FS or USE_USB_HS_IN_HS;
       In addition, external crystal of 10MHz, 12MHz, 19.2MHz, 24MHz, 25MHz, 27MHz, 30MHz or 40MHz is required.