1、功能说明
    1、BKP寄存器读写

2、使用环境

    软件开发环境：KEIL MDK-ARM V5.34
                  IAR EWARM 8.50.1 
    芯片支持：
        N32H730  
        N32H735   
        N32H735EC
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787
    开发板支持：
        N32H787_EVB
        N32H787_HMI
        N32H787_EVB_PRO

3、使用说明
    
    系统配置：
        1、RTC时钟源：LSE
        2、串口配置：
                    - 串口为USART1（TX：PA9  RX：PA10）:
                    - 数据位：8
                    - 停止位：1
                    - 奇偶校验：无
                    - 波特率： 115200 
    使用方法：
        编译后烧录到评估板，向BKP寄存器中写入数据，然后读出打印写入BKP寄存器中的数据

4、注意事项
    无


1. Function description

    1. The BKP register reads and writes

2. Development environment

    Software development environment: KEIL MDK-ARM V5.34
                                      IAR EWARM 8.50.1 
    Supported chips:
        N32H730  
        N32H735   
        N32H735EC
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787
    Development board support：
        N32H787_EVB
        N32H787_HMI
        N32H787_EVB_PRO

3. How to use

    System configuration:

        1. RTC clock source: LSE
        2. Serial port configuration:

                            - Serial port: USART1 (TX: PA9 RX: PA10) :
                            - Data bit: 8
                            - Stop bit: 1
                            - Parity check: None
                            - Baud rate: 115200

    Instructions:
        1. After compiling, it burns to the evaluation board, writes data to the BKP register, and then reads and prints the data written to the BKP register

4. Attention
    None