1、功能说明
    1、描述DAC的用户校准流程

2、使用环境

    软件开发环境：KEIL MDK-ARM V5.34
                  IAR EWARM 8.50.1 
    芯片支持：
        N32H730  
        N32H735   
        N32H735EC
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787

3、使用说明
    系统配置；
        1、时钟源： HSI+PLL
        
        2、系统时钟频率：
            M7核 : 600MHz 
            
        3、端口配置：
            PA4选择为模拟功能DAC1 OUT
            
        4、LOG配置：
            TX  -->  PA9 
            波特率：115200
            数据位：8bit
            停止位：1bit
            无校验
            
        5、DAC配置：
            DAC选择软件触发，无波形生成模式,输出buffer使能, 对外输出到Pin.
            

    使用方法：
        1、编译后将工程程序下载到开发板并复位运行
        2、从串口看打印信息，验证结果.
        
4、注意事项
    无
    
1. Function description

    1,  Describe the user calibration procedure for DAC.

2. Development environment

    Software development environment: KEIL MDK-ARM V5.34
                                      IAR EWARM 8.50.1 
    Supported chips:
        N32H730  
        N32H735   
        N32H735EC
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787

3. How to use
   System Configuration:
        1. Clock source: HSI+PLL
        
        2. System Clock frequency: 
            M7 Core：600MHz 
            
        3. Port configuration:
            PA4 is selected as analog function DAC1 OUT

        4. LOG configuration:
             TX --> PA9 
             Baud rate: 115200
             Data bit: 8bit
             Stop bit: 1bit
             No verification
        5. DAC:
            Software-triggered, waveform generation disabled, output buffer enabled, external output to Pin
     
Usage:
        1, After compiling, download the program  and reset, reset and run
        2. view the print information from the serial port and verify the result.


4. Attention
    None

