1、功能说明
    1、TIM3 CH1 CH2 CH3 CH4输出频率相同占空比不同的PWM
2、使用环境
    软件开发环境：  KEIL MDK-ARM 5.34.0.0
    硬件环境：      基于N32A455VEL7_EVB v1.0.0开发
3、使用说明
    系统配置；
        1、时钟源：
                    HSE=8M,PLL=144M,AHB=144M,APB1=36M,APB2=72M,TIM3 CLK=72M
        2、端口配置：
                    PA6选择为TIM3的CH1输出
                    PA7选择为TIM3的CH2输出
                    PB0选择为TIM3的CH3输出
                    PB1选择为TIM3的CH4输出
        3、TIM：
                    TIM3 CH1 CH2 CH3 CH4周期相等，占空比不等
    使用方法：
        1、编译后打开调试模式，用示波器或者逻辑分析仪观察TIM3 CH1、CH2、CH3、CH4的波形
        2、程序运行后，产生4路周期相等占空比不同的PWM信号
4、注意事项
    无



1. Function description
     1. TIM3 CH1 CH2 CH3 CH4 output PWM with the same frequency and different duty cycle
2. Use environment
     Software development environment: KEIL MDK-ARM 5.34.0.0
     Hardware Environment: Developed based on N32A455VEL7_EVB v1.0.0
3. Instructions for use
     System Configuration;
         1. Clock source:
                     HSE=8M,PLL=144M,AHB=144M,APB1=36M,APB2=72M,TIM3 CLK=72M
         2. Port configuration:
                     PA6 is selected as CH1 output of TIM3
                     PA7 is selected as CH2 output of TIM3
                     PB0 is selected as the CH3 output of TIM3
                     PB1 is selected as CH4 output of TIM3
         3. TIM:
                     TIM3 CH1 CH2 CH3 CH4 equal period, unequal duty cycle
     Instructions:
         1. Open the debug mode after compiling, and observe the waveforms of TIM3 CH1, CH2, CH3, CH4 with an oscilloscope or logic analyzer
         2. After the program runs, generate 4 PWM signals with equal cycles and different duty cycles
4. Matters needing attention
     none