1、功能说明

    1、此例程展示在 RT_Thread 消息队列的创建、发送和接收

2、使用环境

    /* 硬件环境：工程对应的开发硬件平台 */
   开发板：N32L43XM-STB N32L40XM-STB V1.1

3、使用说明

    /* 描述相关模块配置方法；例如:时钟，I/O等 */
    SystemClock：108MHz
    KEY：	KEY1--PA4，
	        KEY2--PA5,
	        KEY3--PA6

    日志：TX--PA9  RX--PA10，波特率：115200
        

    /* 描述Demo的测试步骤和现象 */
    1.编译后下载程序复位运行
    2.接好串口打印工具
    3.本例程创建两个线程，key 线程和 test 线程，key 线程检测按键发送消息队列，test 线程接收消息队列，按下按键（KEY1、KEY2、KEY3）发送消息队列，查看打印日志

4、注意事项
    无

1. Function description
    This routine shows the creation, sending, and receiving of a message queue in RT_Thread

2. Use environment
    Hardware environment: development hardware platform corresponding to the project 
    Development board:      N32G457QEL_EVB V1.1

3. Instructions for use
    Describe the configuration method of related modules; for example: clock, I/O, etc. 
        1.SystemClock：108MHz
        2.KEY：	KEY1--PA4，
	        KEY2--PA5,
	        KEY3--PA6
                     Log: TX--PA9 RX--PA10 Baud rate: 115200

    Describe the test steps and phenomena of Demo 
        1. After compiling, download the program to reset and run;
        2. Connect the serial port printing tool;
        3. This routine creates two threads, the key thread and the test thread. The key thread detects the key sending message queue, and the test thread receives the message queue. 
            Press the key (KEY1、KEY2、KEY3) to send the message queue and view the print log

4. Attention
    None.