1、功能说明
     1、I2S 主模式发送数据完成以后切换成 SPI 主模式发送数据，再切换成 I2S 从模式发送数据
2、使用环境
     软件开发环境：KEIL MDK-ARM 5.30.0.0
     硬件环境：      基于N32G031CL-STB V1.0开发
3、使用说明
     系统配置：
        1、SystemClock：48MHz
        2、GPIO：（主模式 DEMO 板）I2S1: WS--PA4、CK--PA5、SD--PA7
                 （从模式 DEMO 板）I2S1: WS--PA4、CK--PA5、SD--PA7
     使用方法：
        1、编译后下载程序复位运行；
        2、从模式 DEMO 板进入调试模式，先按住主模式 DEMO 板复位键，然后从模式 DEMO 板全速跑，
             再松开主模式 DEMO 板复位键。
4、注意事项
     需要两块 demo 板配合，一块板子烧录主模式程序，一块板子烧录从模式程序，连接两块板子的 VCC 和 GND

1. Function description
    1. After I2S master mode sends data, switch to SPI master mode to send data, and then switch to I2S slave mode to send data
2. Use environment
    Software development environment: KEIL MDK-ARM 5.30.0.0
    Hardware Environment: Developed based on N32G031CL-STB V1.0
3. Instructions for use
    System Configuration;
        1. SystemClock：48MHz
        2. GPIO：(Master mode DEMO board) I2S1: WS--PA4, CK--PA5, SD--PA7
                 (Slave mode DEMO board)  I2S1: WS--PA4, CK--PA5, SD--PA7
    Instructions:
        1. After compiling, download the program to reset and run;
        2. The slave mode DEMO board enters the debug mode, first press and hold the master mode DEMO board reset button, 
		then the slave mode DEMO board runs at full speed,then release the reset button of the master mode DEMO board.
4. Matters needing attention
    Two demo boards are required, one board to burn the master mode program, one board to burn the slave mode program, connect the VCC and GND of the two boards