1、功能说明
    1、通过设定唤醒时间触发中断。
    2、通过唤醒标志位来配置IO输出


2、使用环境

    软件开发环境：KEIL MDK-ARM V5.25

    硬件环境：
    1、基于评估板N32G030C8L7-STB V1.0开发
    2、MCU：N32G030C8L7


3、使用说明

    系统配置；
        1、周期性唤醒时钟源：RTCCLK（1HZ）
        2、串口配置：
                    - 串口为USART1（TX：PA9  RX：PA10）:
                    - 数据位：8
                    - 停止位：1
                    - 奇偶校验：无
                    - 波特率： 115200 


    使用方法：
        1、编译后烧录到评估板，上电后，串口每隔4s会打印I am in rtc_wkup。
            
4、注意事项
    无
    
 
1. Function description

	1. Trigger interrupt by setting wake up time
	2. Configure IO output by wake up flag bit

2. Use environment

	Software development environment: KEIL MDK-ARM V5.25
	Hardware environment:
		1. based on the evaluation board N32G030C8L7-STB V1.0 development
		2. MCU: N32G030C8L7

3. Instructions for use

	System configuration:

		1. periodic wake up clock source: RTCCLK (1HZ)
		2. Serial port configuration:

							- Serial port: USART1 (TX: PA9 RX: PA10) :
							- Data bit: 8
							- Stop bit: 1
							- Parity check: None
							- Baud rate: 115200

	Instructions:
		1. After compilation, it is burned to the evaluation board. After power-on, the serial port will print "I am in rtc_wkup" every 4s

4. Matters needing attention
	None