1、功能说明

    此例程提供了一种DMA用法，用于在外设到RAM之间传输数据。
    

2、使用环境

    软件开发环境：
        IDE工具：KEIL MDK-ARM 5.26
    
    硬件环境：
        开发板 N32G030C8L7-STB V1.0


3、使用说明
	
    1、时钟源：HSE+PLL
    2、主时钟：48MHz
    3、DMA通道：DMA_CH2，DMA_CH3，DMA_CH4，DMA_CH5
    4、SPI1 配置：
            SCK   -->  PA5
            MISO  -->  PA6
            MOSI  -->  PA7
            全双工
            主模式
            8bit传输
            极性：起始为低/第二个边沿
            软件片选
            大端在前MSB
    
    5、SPI2 配置：
            SCK   -->  PB13
            MISO  -->  PB14
            MOSI  -->  PB15
            全双工
            从模式
            8bit传输
            极性：起始为低/第二个边沿
            软件片选
            大端在前MSB
    
    6、USART1配置：
            TX  -->  PA9
            波特率：115200
            数据位：8bit
            停止位：1bit
            无校验

    7、测试步骤与现象
        a，编译下载代码复位运行
        b，从串口看打印信息，验证结果
        
4、注意事项
    无


1. Function description
    This routine provides a DMA usage for transferring data between peripherals and RAM.

2. Use environment
    Software Development environment:
        IDE tool: KEIL MDK-ARM 5.26

    Hardware environment:
        N32G030C8L7-STB V1.0

3. Instructions for use
    1. Clock source: HSE+PLL
    2. Master clock: 48MHz
    3. DMA channels: DMA_CH2, DMA_CH3, DMA_CH4, DMA_CH5
    4. SPI1 configuration:
                SCK   -->  PA5
                MISO  -->  PA6
                MOSI  -->  PA7
    		Full duplex
    		Main mode
    		8 bit transmission
    		Polarity: start at low/second edge
    		Piece of software to choose
    		Big end in front MSB

    5. SPI2 Configuration:
                SCK   -->  PB13 
                MISO  -->  PB14
                MOSI  -->  PB15
    		Full duplex
    		From the pattern
    		8 bit transmission
    		Polarity: start at low/second edge
    		Piece of software to choose
    		Big end in front MSB

    6. USART1 configuration:
                TX  -->  PA9
    		Baud rate: 115200
    		Data bit: 8 bits
    		Stop bit: 1bit
    		No check

    7. Test steps and phenomena
    A. Compile download code reset run
    B. View the printed information from the serial port and verify the result
        
4. Matters needing attention
    None
