1、功能说明
    通过PC13来检测入侵。


2、使用环境

    软件开发环境：KEIL MDK-ARM V5.34.0.0
    硬件开发环境： 
        N32G05x系列：
            基于评估板N32G05xRBQ7_STB V1.0开发
        N32G05x系列：
            基于评估板N32G05xRBL7_STB V1.0开发



3、使用说明

    系统配置；
        1、时钟：LSI
        2、检测口：PC13
        3、串口配置：
                    - 串口为USART1（TX：PA9  RX：PA10）:
                    - 数据位：8
                    - 停止位：1
                    - 奇偶校验：无
                    - 波特率： 115200 


    使用方法：
        1、在KEIL下编译后烧录到评估板，上电后，给PC13触发上升沿变化，串口打印输出Tamper interrupt。
                
                

4、注意事项
    入侵引脚需要接外部下拉



1. Function description
    Intrusion is detected by PC13.



2. Use environment

	Software development environment: KEIL MDK-ARM V5.34.0.0
    Hardware development environment:
         N32G05x series:
            Developed based on the evaluation board N32G05xRBQ7_STB V1.0
         N32G05x series:
            Developed based on the evaluation board N32G05xRBL7_STB V1.0



3. Instructions for use

    System Configuration;
        1. Clock: LSI
        2. Detection port: PC13
        3. Serial port configuration:
                    - Serial port is USART1 (TX: PA9 RX: PA10):
                    - Data bits: 8
                    - Stop bit: 1
                    - Parity: none
                    - Baud rate: 115200


    Instructions:
        1. After compiling under KEIL, burn it onto the evaluation board. After powering on, trigger the rising edge change on PC13 and print out the Tamper interrupt through the serial port.
                               

4. Matters needing attention
    The tamper pin needs to be connected to an external pull-down